Hi! I haver updated The binaries of a athom bulb 15, i was wled and tried to change to esphome, but this proccess brick the device, how can i do this via the serial port? I noticed that it has gnd, vcc, but I don't know which pins are gpio0 and rx/tx.
top of page
Per vedere come funziona, vai al tuo sito pubblicato.
Comments (3)
Non puoi più commentare questo post. Contatta il proprietario del sito per avere più informazioni.
bottom of page
Hello,
I have the same problem and was able to disassemble the plastic dome by steady gently pushing forward and backward to loosen the glue. I can see the pins corresponding to this.
But wich one is RX, TX, Gnd, 0, 3v etc?
Anyone Ideas?
Best