Hi everyone,
i just received a couple of devices from Athom. I managed to install the LED Bulbs and the switches/plugs - altough I bricked one LED when trying to use official tasmota.bin.gz release (followed the description in this board).
Now, with the relays it is entirely different. There is a totally different firmware installed and while I manage to configure the WLAN, I never get access to the web ui. The router shows an IP/DHCP lease, but the device start blinking now and then (did not figure the pattern yet). I could not access any web ui and thus the device appears unusable ... any hints?
I did a nmap scan that showed only one open port:
PORT STATE SERVICE REASON VERSION
5556/tcp open freeciv? syn-ack ttl 255
1 service unrecognized despite returning data. If you know the service/version, please submit the following fingerprint
I bought this device, so that i can use and customize it with tasmota firmware ... that said, is there a good way of opening the plastic cover to get to the esp chip?
Best,
Hannes
PS: the network it is connected to does not have internet access
Same here...only connecting to homekit, but I want to use the relay switches with Home-Assistant....@support: any idea how we can get access to the WebUI?
@johannes.ellinger Please check if you have bought the HomeKit version or the Tasmota based version of the switches. I had the same issue and Athom has identified that I had bought the HomeKit versions. By the way: they cannot be converted/flashed to Tasmota versions...
I got the tasmota version and they worked fine out the box as with other Athom tasmota based devices.