6ch Energy Meter gives strange energy readings

I put channels 1-3 to our house incomping phases.

I have been monitoring about two hours, and current readings are sensibles (I have own made esp32 reader with clamps in same wires what to compare) .

but athoms power readings are crap, example

current_1 3,2A

current_2 1,5A

current_3 2.2A

Power_1 206W

Power_2 27W (this havent increase at all, it was even negative sometime but I rotated clamp)

Power_3 474W

clamps are now phase 1 is different way than phase2 and 3 so these dont show so much negative.

I use newest esphome 2024.12.2

I will this device one day change to measure, but after this couple hours I think I will put to ser.. edit: voltage reading is 229,5- 230,8 V, and that power_2 changes a bit but not over 100W, and when calculating powers with current and voltage nothing of those arent correct