Notice: This is open sources device, fully compatible with Homekit but not certified by Apple

 

DC 5V/DC 7-28V input 10A relay

 

To enable HomeKit remote control, you need a HomePod, an Apple TV 4K, Apple TV HD, or an iPad. Set any of these Apple devices in your house as a HomeKit bridge and connect it to your home Wi-Fi network. Keep in mind that once your HomeKit bridge is set up, it has to be kept online. If it is powered off or disconnected from the Wi-Fi, it will fail to respond when you intend to control the device remotely.

 

Self-Locking:

 

The default setting of the relay is self-locking 

 

Inching Mode:

 

To change self-locking mode to Inching mode, please follow the instruction below

 

Please power off the module and use jump wire which included in the box connect GND to RX, like the picture show

 

Operating voltage: 5V/7-28V DC
relay on/off status respectively
Two input interfaces
Supports to control different voltage ranges
USB port power supply more convenient
Board consumption: <1W
Standby current: 80mA
Max input current: 10A
Max Wattage: 2200W
Relay lifespan: ≥one million times
100M electrical insulation resistance
Electric shock voltage: 1000V
Relay maximum pull time: 15ms
Relay maximum release time: 5ms
Working mode: inching / self-locking
Wireless Standard: 2.4GHz, 802.11 b/g/n
Application: access control, turn on PC, garage door, etc.
Computer application: Remote control computer boot
Operating temperature: -40 degrees to +70 degrees
Operating Humidity 40%-80% RH

 

Homekit 8CH Inching/Self-lock Relay

SKU: R08-HK-1
$41,00 Prezzo regolare
$28,70Prezzo in saldo